Knowledge Base

AudioPoint answers:

• Page:
  Can I use this system anywhere in the world?
• Page:
  Can the users' device change between wifi hotspots?
• Page:
  Can we use the public Wifi for AudioPoint as well?
• Page:
  Does the system need to be connected to the Internet?
• Page:
  How do I make the audio stream private?
• Page:
  How to set up the AudioPoint WiFi Network ideally?
• Page:
  Is the device lip-sync capable?
• Page:
  What can cause short transmission interruptions?
• Page:
  Which MHz transmitter bandwidth is optimal?
• Page:
  Which Wi-Fi band shall I use?
• Page:
  Which WiFi Access Points do work?
• Page:
  Why is my setup on 2.4 GHz not working properly?
• Page:
  Which smartphones or other listening devices can I use with the AudioPoint 3.0?
• Page:
  Shall I use 2.4GHz or 5GHz?

Perhaps also interesting:

• Page:
  How do the devices get their IP address
• Page:
  Do the Barix products support Multicast and IGMP ?
• Page:
  So, I have purchased an Instreamer and an Exstreamer. And now what?
• Page:
  SonicIP Voice - can I change this and record my own ?
• Page:
  Which features are supported by the PC software, ICgraph?
• Page:
  How to create music channels on your network
• Page:
  What to do with the SIP client
• Page:
  What you need to know about the ICgraph
• Page:
  When was RTP Buffering - Frame Based Buffering introduced?
• Page:
  How does the stream switching in the Streaming Client work?
• Page:
  Does the new Streaming Client version support the automatic Remote Firmware?
• Page:
  What is the best way to Stream RTP from PC to Barix Devices?
• Page:
  What to do with VSC support in the Streaming Client?
• Page:
  How does the Barix system work?
• Page:
  How to get the software
• Page:
  How to mount the ESD protection springs?
• Page:
  How to use Bit-reservoir?
• Page:
  What you need to know about the Configuration Update
• Page:
  Which of the 4 methods to use for operating a FW Update
• Page:
  How to customize the default configuration settings of your Barix Audio product.
• Page:
  SonicIP Howto
• Page:
  How to configure multicast?
• Page:
  Protocols used in Barix Products
• Page:
  Are there any known security vulnerabilities with Barix devices?
• Page:
  AND what does BRTP stand for ?
• Page:
  How do I perform a "Serial Rescue" of the device if it becomes unreachable ?
• Page:
  How do I do a web update of a device ?
• Page:
  How do i connect a Barix device to HSPDA, UMTS, CDMA, EVDO, wireless networks ?
• Page:
  How do I set the device back to factory defaults ?
• Page:
  How do emergency messages work ?
• Page:
  How do I get the "status page" of any device ?
• Page:
  Do the Barix products support IPv6 ?
• Page:
  On the fly IP Address change
• Page:
  How to get the IP Address
• Page:
  How much latency should I expect in an Instreamer/Exstreamer setup using BTRP ?
• Page:
  The device already has a password either I don't remember or I don't know, how do I erase it ?
• Page:
  I want to do a broadcast over different subnets, is that possible ?
• Page:
  I want to set up a local network with more than 250 devices, what do i have to do ?
• Page:
  WLAN Broadcast/Multicast Troubleshooting
• Page:
  What if the device is still unreachable after a serial rescue ?
• Page:
  What if my routers don't have a fix IP address from the ISP (Internet service provider) ?
• Page:
  What is SonicIP?
• Page:
  What is AutoIP, IPzator, etc.and how do I use them?
• Page:
  What does RTP stand for ?
• Page:
  Which port/s do your devices commonly use ?
• Page:
  What is the difference in using PCM MSB and PCM LSB?
• Page:
  Windows Media Streaming (MMS/WMA)
• Page:
  What is Digital Rights Management?
• Page:
  SIP with Siemens Gigaset
• Page:
  Which firmware should you use for which hardware?