Skip to main content
Skip table of contents

How do I set the device back to factory defaults ?

  • Look for the "Defaults" button in the configuration page. This procedure will NOT erase the network settings.
  • To revert ALL settings (including the network settings, passwords, etc) to factory defaults the “Reset” button has to be pressed for about 10-15 seconds (depends from used firmware, changes LED blink code when ready) while the Barix Instreamer is powered. Use this method if a connection to the Barix Instreamer cannot be established. If this fails we recommend to perform a “Serial Rescue”
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.