Skip to main content
Skip table of contents

How to change the Hardware for the Exstreamer P5 and Infrared?


The Exstreamer P5 comes with a Control Port. To be able to use the Barix IR Remote Control Kit you need to make some HW changes.


Following hardware is required to make this work:

  • Exstreamer P5
  • IR Remote Control Kit
  • RJ45 Cable

Hardware Changes

  1. Open the IR Remote Control Kit
  2. Take the RJ45 Cable and cut it in the required length
  3. Prepare the RJ45 Pin's 6,7 and 8
  4. Solder the the RJ45 to following ports on the IR board
  • J1-4 --> RJ45 8
  • J1-5 --> RJ45 7
  • J1-8 --> RJ45 6

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.